Sunday, February 22, 2009

Serial port on MyBook



Kind of a low tech mount but it works.
I can now see the bootloader output. I have used a modified Nokia CA-42 data cable for RS232 conversion.


Connected.
NASOx_0800
Mon Jan 21 08:49:25 GMT 2008


U-Boot 1.1.2 (Jan 21 2008 - 08:50:09)

U-Boot code: 48D00000 -> 48D17648 BSS: -> 48D1B2B8
RAM Configuration:
Bank #0: 48000000 32 MB
In: serial
Out: serial
Err: serial
Initialising disks
No FIS received from device 1
Detecting SATA busses:
Bus 0: Found first device OK
Device 0: Model: WDC WD5000AAJS-98YFA0 Firm: 12.01C02 Ser#: WD-WCAS87380126
Type: Hard Disk
Supports 48-bit addressing
Capacity: 476940.0 MB = 465.7 GB (976773168 x 512)
Device 1: not available

IDE read: device 0 block # 63, count 1 ... 1 blocks read: OK
Upper 32M of SDRAM is alias of lower 32M
Hit any key to stop autoboot: 0

IDE device 0: Model: WDC WD5000AAJS-98YFA0 Firm: 12.01C02 Ser#: WD-WCAS87380126
Type: Hard Disk
Supports 48-bit addressing
Capacity: 476940.0 MB = 465.7 GB (976773168 x 512)
... is now current device

IDE read: device 0 block # 300, count 5700 ... 5700 blocks read: OK
## Booting image at 48500000 ...
Image Name: Linux-2.6.17.14
Image Type: ARM Linux Kernel Image (uncompressed)
Data Size: 1231380 Bytes = 1.2 MB
Load Address: 48008000
Entry Point: 48008000
Verifying Checksum ... OK
OK

Starting kernel ...


Cute!

No comments:

Post a Comment